Neotech Pad-It Tuba Harness

Fits most body types and tubas; numerous attachment options easily fit a variety of instruments
Design offers wide range of adjustability features to increase comfort and fit while better balancing the weight of the tuba in the proper playing position
Memory foam padding conforms to your body and wicks away moisture for added comfort
Torso strap adjustable approximately 31″-64″ (78,7cm-162,6cm); Nonmarring connectors
Made in the USA

padded neoprene tuba harness offers a secure strap for playing while standing

Back view: showing top-grade leather support panel

Neotech Pad-It Tuba Harness

The Pad-It Tuba Harness is the ideal accessory for tuba players who wish to stand or march while playing. It features comfortable shoulder pads with high-tech memory foam that conforms to your shoulders for the best weight distribution of the instrument. The memory foam is designed to wick moisture away from the skin to keep you cooler and more comfortable during longer playing sessions.

Fits most body types and tubas
Design offers wide range of adjustability features to increase comfort/fit while better balancing the weight of the tuba in the proper playing position
Memory foam padding conforms to your body and wicks away moisture for added comfort
Numerous attachment options easily fit a variety of instruments
Nonmarring connectors

Pad-It Tuba Harness Instructions


1. Begin by unfastening the center quick disconnect and hold the harness by the two shoulder pads.	2. Place your arms through the openings with the pads resting on your shoulders. Putting on the Pad-It Tuba Harness is very much like wearing a vest.	3. Fasten the center quick disconnect.	4a. Position the torso strap so it fits just below the sternum. You can adjust the torso strap higher on the body by pulling the two webbing tabs as shown.


4b. To adjust the torso strap lower on the body, simply lift the ladder-lock connectors as shown and the webbing will freely adjust to the longer length required.	5a. Set the main adjustment for the torso strap by using the two triglide connectors which are located furthest to the back of the harness.	5b. Minor adjustments to the torso strap can be made by using the two triglide connectors located at the side quick disconnects.	6. Once the torso strap is adjusted properly for fit, you can fine-tune the position of the Weight Distribution Adjustment triglides located on each side of the center quick disconnect by moving them toward the back. This maximizes the support of the instrument once attached.


7. Option 1: If the instrument has a large enough connector ring at the bottom, you may simply clip the two swivel hook connectors directly to it.	7. Option 2: If the ring is too small to accommodate the hooks, apply the loop connectors as follows: a) Thread the nylon webbing loop through the ring on the instrument.	b) Pass the plastic part through the webbing loop.	c) Pull the plastic part to tighten the knot.


d) Repeat with second loop connector.	e) Connect the two swivel hooks on the harness to the loop connectors on the instrument.	8. Adjust the length of the straps using the same method as described in step 4.	9. For added stability, attach the upper strap to the instrument’s top strap ring.